Ip Udp-Broadcast-Address; Ip Udp-Helper Udp-Port - Dell S4810 Reference Manual

ip udp-broadcast-address

Configure an IP UDP address for broadcast.
S4810
Syntax
ip udp-broadcast-address address
To delete the configuration, use the no ip udp-broadcast-address address
command.
Parameters
address
Defaults Not configured.
Command INTERFACE (config-if)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.7.0
Pre-version
8.3.7.0
Usage When a UDP broadcast packet is flooded out of an interface, and the outgoing
Information interface is configured using this command, the outgoing packet's IP destination
address is replaced with the configured broadcast address.
Related
debug ip udp-helper
Commands
console.
show ip udp-helper

ip udp-helper udp-port

Enable the UDP broadcast feature on an interface either for all UDP ports or a specified list of UDP ports.
S4810
Syntax
ip udp-helper udp-port [udp-port-list]
To disable the UDP broadcast on a port, use the no ip udp-helper udp-port
[udp-port-list] command.
824
Enter an IP broadcast address in dotted decimal format
(A.B.C.D).
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
— enables debug and displays the debug information on a
— displays the configured UDP helpers on all interfaces.
Interfaces