vlan-name
Defaults
Disabled.
Command
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
Related
protocol lldp (Configuration)
Commands
debug lldp interface
show lldp neighbors
advertise dot3-tlv
Advertise dot3 TLVs (Type, Length, Value).
S4810
Syntax
advertise dot3-tlv {max-frame-size}
To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-frame-
size} command.
Parameters
max-frame-
size
Defaults
none
Command
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Modes
1078
Enter the keywords vlan-name to advertise the vlan-name
TLV. This keyword is only supported on the C-Series and S-
Series.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series. Added the vlan-name option.
Introduced on the C-Series.
Introduced on the E-Series.
— enables LLDP globally.
— debugs LLDP.
— displays the LLDP neighbors.
Enter the keywords max-frame-size to advertise the dot3
maximum frame size.
Link Layer Discovery Protocol (LLDP)