Show Ip Bgp Detail - Dell S4810 Reference Manual

Version 7.8.1.0
Version 7.7.1.0
Usage
To determine a BGP session flap, both a route-down event and a subsequent
Information
route-up event corresponding to a single route are considered. As a result, a flap
event is penalized only one time during the route-down event. The subsequent
route-up event corresponding to the same route is not considered as a flap and is
not penalized.
The history paths that the show ip bgp command displays contain only the prefix
and the next-hop information. The next-hop information shows the ip address of
the neighbor. It does not show the actual next-hop details.
The following describes the show ip bgp damp command shown in the
following example.
Field
Network
From
Reuse
Path
Example
Dell#show ip bgp dampened-paths
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, *
valid, > best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed
Origin codes: i - IGP, e - EGP, ? - incomplete
d
Dell#

show ip bgp detail

Display BGP internal information for the IPv4 Unicast address family.
S4810
Syntax
show ip bgp [ipv4 unicast] detail
Defaults none
Border Gateway Protocol
Introduced on the S-Series.
Introduced on the C-Series.
Description
Displays the network ID to which the route is dampened.
Displays the IP address of the neighbor advertising the
dampened route.
Displays the hour:minutes:seconds until the dampened
route is available.
Lists all the ASs the dampened route passed through to
reach the destination network.
n - network,
Network
55.0.0.0/24 172.16.0.2
D - denied, S - stale
From Reuse Path
00:36:23 200
461