Iscsi Priority-Bits - Dell S4810 Reference Manual

Parameters
enable
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0

iscsi priority-bits

Configure the priority bitmap that advertises in the iSCSI application TLVs.
S4810
Syntax
iscsi priority-bits
To remove the configured priority bitmap, use the no iscsi priority-bits
command.
Defaults 4 (0x10 in the bitmap)
Command PROTOCOL LLDP (only on the global, not on the interface)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
954
Enter the keyword enable to enable the iSCSI optimization
feature.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on MXL 10/40GbE Switch IO Module.
Introduced on the S4820T.
Introduced on the S4810.
iSCSI Optimization