Dell S4810 Reference Manual page 774

Command
•
Modes
•
Command
Version 9.0.2.0
History
Version 9.2(0.2)
Version 9.1(0.0)
Version 8.3.12.1
Version 8.3.11.4
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 8.2.1.2
Version 8.2.1.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.4.1.0
Version 6.3.1.0
Usage
Use the show interfaces command for details on a specific interface.
Information
On the S4810, the show interface output displays incorrect rate information
details over time for link monitoring when the rate-interval is configured for 5
seconds. Dell Networking recommends using higher rate-intervals such as 15 to
299 seconds to minimize the errors seen.
774
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then
the tunnel ID. The range is from 1 to 16383.
EXEC
EXEC Privilege
Introduced on the S6000.
Added support for the tunnel interface type.
Updated ManagementEthernet output to include two global
IPv6 addresses on S4810 and Z9000 and added output
example showing OpenFlow instance ID.
Updated command output to support multiple IPv6
addresses on S4810.
Output expanded to support eSR4 optics in Z9000.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Included SFP and SFP+ optics power detail in the E-Series
and C-Series output.
Added support for 4093 VLANs on the E-Series ExaScale.
Prior releases supported 2094.
Introduced on the E-Series ExaScale.
Output expanded to include SFP+ media on the C-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Changed the organization of the display output.
Added the Pluggable Media Type field in the E-Series
TeraScale output.
Interfaces