Dell S4810 Reference Manual page 459

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
The show ip bgp community-list command without any parameters lists BGP
Information
routes matching the Community List and the output is the same as for the show
ip bgp command output.
The following describes the show ip bgp community-list pass command
shown in the following example.
Field
Network
Next Hop
Metric
LocPrf
Weight
Path
Example
Dell#conf t
Dell(conf)#ip community-list cl1
Dell(config-community-list)#permit 1000:1
Dell(config-community-list)#end
Dell#show ip bgp community-list cl1
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, *
valid, > best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed
Origin codes: i - IGP, e - EGP, ? - incomplete
Border Gateway Protocol
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Displays the destination network prefix of each BGP route.
Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then local routes exist in the routing
table.
Displays the BGP route's metric, if assigned.
Displays the BGP LOCAL_PREF attribute for the route.
Displays the route's weight.
Lists all the ASs the route passed through to reach the
destination network.
n - network, D - denied, S - stale
459