Ets Commands; Bandwidth-Percentage - Dell S4810 Reference Manual

Example
Dell(conf)# show stack-unit all stack-ports all pfc details
(Summary)
stack unit 0 stack-port all
stack unit 1 stack-port all

ETS Commands

The following ETS commands are supported on the S4810 platform.

bandwidth-percentage

Configure the bandwidth percentage allocated to priority traffic in port queues.
S4810
Syntax
bandwidth-percentage percentage
To remove the configured bandwidth percentage, use the no bandwidth-
percentage command.
Parameters
percentage
Defaults none
Command QOS-POLICY-OUT-ETS
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Data Center Bridging (DCB)
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
(Optional) Enter the bandwidth percentage. The percentage
range is from 1 to 100% in units of 1%.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
537