Set Comm-List Delete - Dell S4810 Reference Manual

Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
set level
Commands
set metric
set metric-type
set tag

set comm-list delete

To remove the specified community list from the BGP route's COMMUNITY attribute, configure a filter.
S4810
Syntax
set comm-list community-list-name delete
To insert the community list into the COMMUNITY attribute, use the no set
comm-list community-list-name delete command.
Parameters
community-
list-name
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
286
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— specify the OSPF area for route redistribution.
— specify the metric value assigned to redistributed routes.
— specify the metric type assigned to redistributed routes.
— specify the tag assigned to redistributed routes.
Enter the name of an established Community list, up to 140
characters.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Access Control Lists (ACL)