Dell S4810 Reference Manual page 1253

authentication-
algorithm
key-
encryption-
type
key
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Version 8.4.2.0
Version
8.3.19.0
Usage
Before you enable IPsec encryption on an OSPFv3 interface, first enable IPv6
Information
unicast routing globally, configure an IPv6 address and enable OSPFv3 on the
interface, and assign the interface to an area.
An SPI value must be unique to one IPsec security policy (authentication or
encryption) on the router. Configure the same encryption policy (same SPI and key)
on each OSPFv3 interface in a link.
To remove an IPsec encryption policy from an interface, enter the no ipv6 ospf
encryption spi number command. To remove null authentication on an
interface to allow the interface to inherit the authentication policy configured for
the OSPFv3 area, enter the no ipv6 ospf no ipv6 ospf encryption null
command.
Open Shortest Path First (OSPFv2 and OSPFv3)
3DES - 48 or 96 hex digits; DES - 16 or 32 hex digits; AES-
CBC -32 or 64 hex digits for AES-128 and 48 or 96 hex digits
for AES-192.
Specifies the authentication algorithm to use for encryption.
Valid values are MD5 or SHA1.
(OPTIONAL) Specifies if the authentication key is encrypted.
Valid values: 0 (key is not encrypted) or 7 (key is encrypted).
Text string used in authentication.
For MD5 authentication, the key must be 32 hex digits (non-
encrypted) or 64 hex digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits
(non-encrypted) or 80 hex digits (encrypted).
Introduced on the S4810 and Z9000.
Introduced on the E-Series TeraScale.
Introduced on the S4820T.
1253