Ip Community List Commands; Ip Community-List; Show Ip Community-Lists - Dell S4810 Reference Manual

IP Community List Commands

IP community list commands are supported on the S4810 platform.

ip community-list

Enter COMMUNITY-LIST mode and create an IP community-list for BGP.
S4810
Syntax
ip community-list comm-list-name
To delete a community-list, use the no ip community-list comm-list-name
command.
Parameters
comm-list-
name
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
pre-Version
6.1.1.0
Example
Dell(conf)#ip community-list TestComList
Dell(config-community-list)#

show ip community-lists

Display configured IP community lists in alphabetic order.
S4810
Syntax
show ip community-lists [name]
Parameters
name
300
Enter a text string as the name of the community-list, up to
140 characters.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the E-Series.
(OPTIONAL) Enter the name of the standard or extended IP
community list, up to 140 characters.
Access Control Lists (ACL)