Dell S4810 Reference Manual page 1220

Parameters
process-id
vrf vrf-name
link-state-id
adv-router ip-
address
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage The following describes the show ip ospf process-id database summary
Information
command shown in the following example.
1220
Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Enter the keyword vrf followed by the name of the VRF to
view LSA routing information corresponding to the OSPF
process that is tied to a specific VRF.
(OPTIONAL) Specify LSA ID in dotted decimal format. The
LSA ID value depends on the LSA type, and it can be one of
the following:
• the network's IP address for Type 3 LSAs or Type 5 LSAs
• the router's OSPF router ID for Type 1 LSAs or Type 4
LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
(OPTIONAL) Enter the keywords adv-router then the IP
address of an Advertising Router to display only the LSA
information about that router.
EXEC
EXEC Privilege
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Open Shortest Path First (OSPFv2 and OSPFv3)