Bfd Neighbor - Dell S4810 Reference Manual

Version
8.3.10.0
Version 8.2.1.0
Version 7.6.1.0
Version 7.4.1.0
Example
Dell(conf-if-gi-0/3)#bfd interval 250 min_rx 300 multiplier 4
role passive
Dell(conf-if-gi-0/3)#

bfd neighbor

Establish a BFD session with a neighbor.
S4810
Syntax
bfd neighbor ip-address
To remove the BFD session with the neighbor, use the no bfd neighbor ip-
address command.
Parameters
ip-address
Defaults none
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.0.0
Version
8.3.19.0
Version
8.3.10.0
Version 8.2.1.0
Version 7.6.1.0
Version 7.5.1.0
366
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the IP address of the neighbor in dotted decimal
format (A.B.C.D).
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Added support for VLAN and port-channel interfaces on the
E-Series.
Bidirectional Forwarding Detection (BFD)