Neighbor Soft-Reconfiguration Inbound - Dell S4810 Reference Manual

Related show ipv6 prefix-list
Commands

neighbor soft-reconfiguration inbound

Enable a BGP soft-reconfiguration and start storing updates for inbound IPv6 unicast routes.
S4810
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
Parameters
ipv4-address |
ipv6-address
peer-group-
name
Defaults Disabled.
Command ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.4.1.0
Version
8.3.19.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.4.1.0
Usage This command enables soft-reconfiguration for the specified BGP neighbor. BGP
Information stores all updates for inbound IPv6 unicast routes the neighbor receives but does
not reset the peer-session.
498
— View the selected IPv6 prefix-list.
Enter the IP address of the neighbor for which you want to
start storing inbound routing updates.
Enter the name of the peer group for which you want to start
storing inbound routing updates.
Added support for IPv4 multicast and IPv4 unicast address
families.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the C-Series.
Introduced
CAUTION: Inbound update storage is a memory-intensive operation. The
entire BGP update database from the neighbor is stored in memory
regardless of the inbound policy results applied on the neighbor.
Border Gateway Protocol