Neighbor Update-Source - Dell S4810 Reference Manual

Version 7.8.1.0
Version 7.7.1.0
Usage
Timer values configured with the neighbor timers command override the timer
Information
values configured with any other command.
When two neighbors, configured with different keepalive and holdtime values,
negotiate for new values, the resulting values are as follows:
•
•

neighbor update-source

Enable the E-Series software to use Loopback interfaces for TCP connections for BGP sessions.
S4810
Syntax
neighbor {ip-address | peer-group-name} update-source interface
To use the closest interface, use the no neighbor {ip-address | peer-
group-name} update-source interface command.
Parameters
ip-address
peer-group-
name
interface
Defaults Not configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
442
Introduced on the S-Series.
Introduced on the C-Series.
the lower of the holdtime value is the new holdtime value, and
whichever is the lower value; one-third of the new holdtime value, or the
configured keepalive value, is the new keepalive value.
Enter the IP address of the peer router in dotted decimal
format.
Enter the name of the peer group to disable all routers within
the peer group.
Enter the keyword loopback then a number of the
Loopback interface. The range is from 0 to 16383.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Border Gateway Protocol