Dell S4810 Reference Manual page 711

Field
RPM Failover
Record
Last Data Sync
Record
Example
Dell#show redundancy
-- RPM Status --
------------------------------------------------
RPM Slot ID:
RPM Redundancy Role: Primary
RPM State:
RPM SW Version:
Link to Peer:
-- PEER RPM Status --
------------------------------------------------
RPM State:
RPM SW Version:
-- RPM Redundancy Configuration --
------------------------------------------------
Primary RPM:
Auto Data Sync:
Failover Type:
Auto reboot RPM:
Auto failover limit: 3 times in 60 minutes
-- RPM Failover Record --
------------------------------------------------
Failover Count:
Last failover timestamp:
Last failover Reason:
-- Last Data Block Sync Record: --
------------------------------------------------
High Availability (HA)
Description
• the parameter for auto failover limit control (the
redundancy auto-failover-limit command)
•
Displays the following information:
• RPM failover counter (to reset the counter, use the
redundancy reset-counter command)
• the time and date of the last RPM failover
• the reason for the last RPM failover
Displays the data sync information and the timestamp for
the data sync:
• Start-up Config is the contents of the startup-config file.
• Line Card Config is the line card types configured and
interfaces on those line cards.
• Runtime Event Log is the contents of the Event log.
• Running Config is the current running-config.
This field only appears when you enter the command from
the Primary RPM.
1
Active
7.5.1.0
Up
Standby
7.5.1.0
rpm0
Full
Hot Failover
Enabled
1
Jul 13 2007 21:25:32
User request
711