Ip Msdp Mesh-Group - Dell S4810 Reference Manual

ip msdp mesh-group

To be a member of a mesh group, configure a peer.
S4810
Syntax
ip msdp mesh-group {name} {peer address}
To remove the peer from a mesh group, use the no ip msdp mesh-group
{name} {peer address} command.
Parameters
name
peer address
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 6.2.1.1
Usage An MSDP mesh group is a mechanism for reducing SA flooding, typically in an
Information intra-domain setting. When some subset of a domain's MSDP speakers are fully
meshed, they can be configured into a mesh-group. If member X of a mesh-group
receives a SA message from an MSDP peer that is also a member of the mesh-
group, member X accepts the SA message and forwards it to all of its peers that are
not part of the mesh-group. However, member X cannot forward the SA message
to other members of the mesh-group.
Multicast Source Discovery Protocol (MSDP)
Enter a string of up to 16 characters long for as the mesh
group name.
Enter the peer address in a dotted decimal format (A.B.C.D.).
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
1115