Area Encryption - Dell S4810 Reference Manual

Defaults Not configured.
Command ROUTER OSPFv3
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Version
8.3.19.0
Version 8.4.2.0
Usage Before you enable IPsec authentication on an OSPFv3 area, you must first enable
Information OSPFv3 globally on the router. Configure the same authentication policy (same SPI
and key) on each interface in an OSPFv3 link.
An SPI number must be unique to one IPsec security policy (authentication or
encryption) on the router.
If you have enabled IPsec encryption in an OSPFv3 area with the area
encryption command, you cannot use the area authentication command in
the area at the same time.
The configuration of IPsec authentication on an interface-level takes precedence
over an area-level configuration. If you remove an interface configuration, an area
authentication policy that has been configured is applied to the interface.
To remove an IPsec authentication policy from an OSPFv3 area, enter the no area
area-id authentication spi number command.
Related
ipv6 ospf authentication
Commands
interface.
show crypto ipsec policy
policies.

area encryption

Configure an IPsec encryption policy for OSPFv3 packets in an OSPFv3 area.
S4810
Syntax
area area-id encryption ipsec spi number esp encryption-
algorithm [key-encryption-type] key authentication-algorithm
[key-encryption-type] key
1238
Introduced on the S4810 and Z9000.
Introduced on the S4820T.
Introduced on the E-Series TeraScale.
– configures an IPsec authentication policy on an OSPFv3
– displays the configuration of IPsec authentication
Open Shortest Path First (OSPFv2 and OSPFv3)