Ip Dhcp Snooping Binding - Dell S4810 Reference Manual

Networking OS version 8.2.1.0 extends DHCP Snooping to Layer 2. You do not
have to enable relay agent to snoop on Layer 2 interfaces.

ip dhcp snooping binding

Create a static entry in the DHCP binding table.
S4810
Syntax
[no] ip dhcp snooping binding mac address vlan-id vlan-id ip
ip-address interface type slot/port lease number
Parameters
mac address
vlan-id vlan-id
ip ip-address
interface type
slot/port
lease time
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
630
Enter the keyword mac then the MAC address of the host to
which the server is leasing the IP address.
Enter the keywords vlan-id then the VLAN to which the
host belongs. The range is from 2 to 4094.
Enter the keyword ip then the IP address that the server is
leasing.
Enter the keyword interface then the type of interface to
which the host is connected:
• For an 10/100 Ethernet interface, enter the keyword
fastethernet.
• For a Gigabit Ethernet interface, enter the keyword
gigabitethernet.
• For a Ten-Gigabit Ethernet interface, enter the keyword
tengigabitethernet.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE.
Enter the slot and port number of the interface.
Enter the keyword lease then the amount of time the IP
address are leased. The range is from 1 to 4294967295.
EXEC
EXEC Privilege
Introduced on the S6000.
Dynamic Host Configuration Protocol (DHCP)