Related
dcb-policy input stack-unit stack-ports all
Commands
policy.
description
Enter a text description of the DCB policy (PFC input or ETS output).
S4810
Syntax
description text
To remove the text description, use the no description command.
Parameters
text
Defaults
none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Related
•
Commands
•
•
•
ets mode on
Enable the ETS configuration so that scheduling and bandwidth allocation configured in an ETS output
policy or received in a DCBX TLV from a peer can take effect on an interface.
S4810
Syntax
ets mode on
To remove the ETS configuration, use the no ets mode on command.
Data Center Bridging (DCB)
Enter the description of the output policy. The maximum is
32 characters.
DCB INPUT POLICY
DCB OUTPUT POLICY
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
dcb-input
— creates a DCB PFC input policy.
dcb-policy input
— applies the output policy.
dcb-output
— creates a DCBETS output policy.
dcb-policy output
— applies the output policy.
— applies the specified DCB input
543