Set Local-Preference - Dell S4810 Reference Manual

Related
set automatic-tag
Commands
set metric
set metric-type
set tag

set local-preference

To set the BGP LOCAL_PREF attribute for routers within the local autonomous system, configure a filter.
S4810
Syntax
set local-preference value
To delete a BGP LOCAL_PREF attribute, use the no set local-preference
command.
Parameters
value
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage The set local-preference command changes the LOCAL_PREF attribute for
Information
routes meeting the route map criteria. To change the LOCAL_PREF for all routes,
use the bgp default local-preference command.
290
— computes the tag value of the route.
— specifies the metric value assigned to redistributed routes.
— specifies the metric type assigned to redistributed routes.
— specifies the tag assigned to redistributed routes.
Enter a number as the LOCAL_PREF attribute value. The
range is from 0 to 4294967295.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Access Control Lists (ACL)