Dampening - Dell S4810 Reference Manual

Related
show interfaces dampening
Commands

dampening

dampening
Configure dampening on an interface.
S4810
Syntax
dampening [[[[half-life] [reuse-threshold]] [suppress-
threshold]] [max-suppress-time]]
Parameters
half-life
reuse-
threshold
suppress-
threshold
max-suppress-
time
Defaults Disabled.
Command INTERFACE (conf-if-)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
742
— displays interface dampening information.
— configures dampening on an interface.
Enter the number of seconds after which the penalty is
decreased. The penalty decreases half after the half-life
period expires. The range is from 1 to 30 seconds. The
default is 5 seconds.
Enter a number as the reuse threshold, the penalty value
below which the interface state is changed to "up". The
range is from 1 to 20000. The default is 750.
Enter a number as the suppress threshold, the penalty value
above which the interface state is changed to "error
disabled". The range is from 1 to 20000. The default is 2500.
Enter the maximum number for which a route can be
suppressed. The default is four times the half-life value. The
range is from 1 to 86400. The default is 20 seconds.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Interfaces