Group - Dell S4810 Reference Manual

the speed of the first interface configured and enabled in the Port Channel. If that
first interface goes down, the Port Channel does not change its designated speed;
disable and re-enable the Port Channel or change the order of the channel
members configuration to change the designated speed. If the Port Channel
contains a mix of interfaces with 100 Mb/s speed and 1000 Mb/s speed, the
software disables those interfaces whose speed does not match the speed of the
first interface configured and enabled in the Port Channel. If that first interface
goes down, the Port Channel does not change its designated speed; disable and
re-enable the Port Channel or change the order of the channel members
configuration to change the designated speed. For more information about Port
Channels, refer to the Dell Networking OS Configuration Guide.
Related
description
Commands
interface port-channel
shutdown

group

Group two LAGs in a supergroup ("fate-sharing group" or "failover group").
S4810
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number
command.
Parameters
group_number
port-channel
number
Defaults none
Command PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
810
— assigns a descriptive text string to the interface.
— creates a Port Channel interface.
— disables/enables the port channel.
Enter an integer from 1 to 32 that uniquely identifies this LAG
fate-sharing group.
Enter the keywords port-channel then an existing LAG
number. Enter this keyword/variable combination twice,
identifying the two paired LAGs.
Introduced on the S6000.
Introduced on the S4820T.
Interfaces