Console Cover Seal; Lock Cylinder Removal - Jeep 1987 Wrangler Workshop Manual

DETACHABLE COMPONENTS
€3$
SEAT ASSEMBLIES
€3$
, 'in-- ^'1 IN,,.
s
j11111?--
A. Console
E.
Lock
B. Seal F.
Cylinder
C. Cover G. Cable
D. Retainer H. Striker
101256
The floor console cover is provided with a lock
and two depressions designed to hold bever-
age containers. The bottom of the floor console
is equipped with a hole, in the rear, allowing ice
water to drain onto the ground.
The oval head key is utilized to lock and unlock
the cover.
Removal
Open the console cover.
Remove the screws attaching the console to
the floorpan.
Remove the console assembly from the vehicle.
Installation
Position the console assembly in the vehicle.
Align the drain hole with the hole in the floorpan
and install the attaching screws.
Close and latch the console cover.
Console Cover Seal
The console cover seal (B) is attached to the
console. The foam seal may be replaced after
opening the cover.
Console Cover Lock
Lock Cylinder Removal
101257
SE
I.S
N
O
T
E
S
l
Open the console cover (C).
Remove the screw attaching the retainer (D) to
the lock (E). Remove the retainer from the lock.
49