Jeep 1987 Wrangler Workshop Manual page 82

DETACHABLE COMPONENTS
ROLL BAR
Disconnect the seat belts at the roll bar anchor
point (C).
Remove the screws securing the roll bar to the
floor pan at the front and rear anchor points (D)
(E) and remove the roll bar.
INSTALLATION
Apply sealant to the areas in the wheelhouse
and on the floor pan where the roll bar sets.
Position the seat belts at the roll bar anchor
point and tighten the retaining screws with 43-
62 N*n (32-46 ft. lbs) torque.
Position the roll bar extensions and install and
torque the retaining screws with 43-62 N*m.
(31-45 ft.-lbs) torque.
Install the extension bars.
Install the soft top or top enclosure as de-
scribed in this manual.
Position the roll bar in the vehicle and tighten
the retaining screws with 60-90 N»M (44-66 ft.-
lbs) torque.
P-52