NEC Univerge SV8100 Features And Specifications Manual page 124

Issue 1.0
Program
Program Name
Number
20-08-17 Class of Service Options
(Outgoing Call Service) – ARS
Override of Trunk Access Map
21-02-01 Trunk Group Routing for
Extensions
26-01-01 Automatic Route Selection
Service – ARS Service
26-01-02 Automatic Route Selection
Service – Network Outgoing Inter-
Digit ARS Timer
26-01-03 Automatic Route Selection
Service – ARS Misdialed Number
Handling
26-01-06 Automatic Route Selection
Service – Class of Service Match
Access
2 - 100
Description/Comments
Turns Off or On an extension
capability to override the trunk
access map programming (Program
14-07-01 and Program 15-06-01) for
outgoing calls.
Use this program to assign Program
14-06 routes to extensions.
Enable (1) or Disable (0) ARS.
With Networking, this timer (0~64800
seconds) replaces Program 20-03-
04 when determining if all network
protocol digits are received. If ARS is
enabled at Site B, this timer can be
programmed for 5 (500 msec) at Site
A. If ARS is disabled and Site B is
using F-Route for outbound dialing,
this timer should be programmed for
30 (3 seconds) at Site A.
If a user dials a number not
programmed in ARS, this option
determines if the system should
Route over trunk group 1 (0) or Play
error tone (1).
With the ARS Class of Service
Match Access feature, you can
determine whether or not the system
should allow a call based on the
COS assigned to the Dial Analysis
Table (Program 26-02). This change
can be used to create a tenant-like
application. It then uses the trunk
group set in the Additional Entry in
Program 26-02-03 to place the out-
going call. When this feature is
enabled, the calls are routed in
sequential order, and forward –
provided the Class of Service for the
trunk groups match.
UNIVERGE SV8100
Assigned Data
0 = Off
1 = On
(default = 0 for COS
01~15)
Day/Night Mode: 1~8
Route Table Number:
0~100
(0 = No Setting)
(default = 1)
0 = Disable (Off)
1 = Enable (On)
(default = 0)
0~64800 (seconds)
(default = 30 seconds)
0 = Route to Trunk
Group 1
1 = Play Warning Tone
to Dialer
(default = 0)
0 = Disable (Off)
1 = Enable (On)
(default = 0)
Automatic Route Selection
Level
1 2 3