NEC Univerge SV8100 Features And Specifications Manual page 128

Issue 1.0
Program
Program Name
Number
26-11-01 Transit Network ID Table –
Transmit Network ID (Carrier ID)
44-01-01 System Options for ARS/F-Route
– ARS/F-Route Time Schedule
44-02-01 Dial Analysis Table for ARS/
F-Route Access – Dial
44-02-02 Dial Analysis Table for ARS/
F-Route Access – Service Type
44-02-03 Dial Analysis Table for ARS/
F-Route Access – Additional Data
44-02-04 Dial Analysis Table for ARS/
F-Route Access – Dial Tone
Simulation
2 - 104
Description/Comments
Enter the Transit Network Selection
information element to be added to
an ARS call using an ISDN trunk.
This information element identifies a
requested transit network.
Select whether the ARS/F-Route
feature should use the time schedule
(0=not used, 1=used). If this option is
set to 0, the F-Route table selected
is determined only by the digits
dialed without any relation to the day
or time of the call. If this option is set
to 1, the system first refers to
Program 44-10. If there is a match,
the pattern defined in that program is
used. If not, the F-Route pattern in
Program 44-09 and time setting in
Program 44-08 are used.
Set the Dial digits for the
Pre-Transaction Table for selecting
ARS/F-Route (eight digits max: 1~9,
#
0 , @). To enter a wild card/don't
care digit, press Line Key 1 to enter
an @ symbol.
Set the Service Type (0~3) for the
Pre-Transaction Table for selecting
ARS/F-Route.
If a Service Type is set to F-Route in
Program 44-02-02, set which
F-Route table to be used.
Determine if the Dial Tone Simulation
is On (1) or Off (0) for the
Pre-Transaction Table for selecting
ARS/F-Route. If enabled, this option
sends dial tone to the calling party
once the routing is determined. This
may be required if the central office
at the destination does not send dial
tone.
UNIVERGE SV8100
Assigned Data
0000~9999
(Fixed four digits)
(default not assigned)
0 = Not Used
1 = Used
(default = 0)
Up to eight digits
(Use line key 1 for a
'Don't Care' digit, @)
(default not assigned)
0 = No Setting (None)
1 = Extension Call
(Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension
Analyze Table (Option)
(default = 0)
1=Delete Digit = 0~255
(255 : Delete All Digits)
2=0~500 (0 = No
Setting)
3=Dial Extension
Analyze Table Number
= 0~4
(0 = No Setting)
(default = 0)
0 = Off
1 = On
(default = 0)
Automatic Route Selection
Level
1 2 3