Show Ipv6 Ospf Neighbor - D-Link DES-7200 Cli Reference Manual

DES-7200 CLI Reference Guide
Related
commands
37.2.4

show ipv6 ospf neighbor

Use this command to show the neighbor information of the OSPFv3 process.
show ipv6 ospf [process- id] neighbor [interface-type interface-number [detail]|
neighbor-id |detail]
Parameter
description
Command
mode
Examples
Designated Router (ID) 2.2.2.2
Interface Address fe80::c800:eff:fe84:1c
Backup Designated Router (ID) 1.1.1.1
Interface Address fe80::2d0:22ff:fe22:2223
Timer interval configured, Hello 10, Dead 40, Wait 40, Retransmit
5
Hello due in 00:00:02
Neighbor Count is 1, Adjacent neighbor count is 1
Hello received 26 sent 26, DD received 5 sent 4
LS-Req received 1 sent 1, LS-Upd received 3 sent 6
LS-Ack received 6 sent 2, Discarded 0
Command Description
ipv6 router ospf Start the OSPFv3 routing process.
Enable the interface to participate in the OSPFv3
ipv6 ospf area
process.
Parameter Description
process- id OSPFv3 process number, 1-65535
detail Show details about the neighbor.
interface-type
Interface type And interface number
interface-number
neighbor-id Neighbor ID
Privileged mode.
The following command shows the brief information about the OSPF
neighbor.
DES-7210# show ipv6 ospf neighbor
OSPFv3 Process (1), Neighbores, 1 is Full:
Neighbor ID Pri
Instance ID
2.2.2.2 1 Full/DR
0
Chapter 37 OSPFv3 Configuration Commands
State Dead Time
00:00:33
Interface
FastEthernet 1/0
37-29