Setting Statistics Baselines - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

Setting Statistics Baselines

You can set a statistics baseline for a bridge group (by using the baseline bridge
command) or for a bridge interface (by using the baseline bridge interface
command).
baseline bridge
baseline bridge interface
Use to set a statistics baseline for a specified bridge group.
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
Example
host1#baseline bridge westford03
There is no no version.
See baseline bridge.
Use to set a statistics baseline for a particular network interface belonging to a
bridge group.
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
You must specify the following:
interfaceType One of the following bridge interface types listed in Interface
Types and Specifiers in JUNOSe Command Reference Guide:
atm
fastEthernet
gigabitEthernet
tenGigabitEthernet
interfaceSpecifier Particular interface; format varies according to interface
type; see Interface Types and Specifiers in JUNOSe Command Reference Guide
for information
Example
host1#baseline bridge interface atm 3/3.1
There is no no version.
See baseline bridge interface.
Chapter 15: Configuring Transparent Bridging
Monitoring Transparent Bridging
491