Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 761

loopback command
ATM interfaces......................................................31
POS interfaces....................................................368
Loopback control OAM PDUs
description of......................................................231
sending of
for termination of loopback.........................240
start of loopback of remote peee
by local entity..............................................240
viewing...............................................................253
loopback for ATM VC integrity
cells......................................................................17
configuring......................................................33, 35
F4 OAM cells.........................................................17
handling of received cells......................................20
loopback frames
forwarding of
from the parser to the subordinate
sublayer...................................................233
processing by the packet parser
transmission to the multiplexer...................233
lost-link timer
and Ethernet OAM link-fault management..........236
equivalent to
product of PDU timer and loss
threshold..................................................236
resetting OAM discovery.....................................236
low threshold
for OAM link monitoring
generation of Event notification PDU...........237
response when exceeded.............................237
specifying
for frame error events.................................244
for frame seconds summary error
events......................................................244
for symbol error events...............................244
low threshold value
recommendation for setting
for link-fault monitoring...............................242
M
MAC (media access control) addresses
bridging overview...............................................467
configuring for S-VLANs..............................170, 183
configuring for VLANs.........................................170
removing from forwarding table.........................490
using with bridged Ethernet................................447
validation on bridged Ethernet interfaces...........447
macro command.......................................................599
macros
using to configure dynamic interfaces................598
magic numbers..........................................................263
manuals
comments on.....................................................xxxi
map class, Frame Relay fragmentation......................119
map entries, Frame Relay..................................124, 140
map list, using to configure NBMA interfaces...............40
map-class frame-relay command...............................119
map-group command..................................................42
map-list command.......................................................42
Marker response OAM PDUs
circumstances of non-transmission of.................241
link event caused by exceeding high threshold
and disabling sending of..............................241
maximum payload size, Frame
Relayfragmentation................................................119
maximum receive unit. See MRU
media access control addresses See MAC addresses
member-interface command.....................140, 317, 331
message of the minute messages. See MOTM
messages
MFR
aggregating OC3/STM1 lines...............................134
MLFR (Multilink Frame Relay)
aggregating T1 or E1 lines...................................133
aggregation limits...............................................136
bundle................................................................133
bundle limits.......................................................136
configuring..........................................................138
interfaces, monitoring.........................................140
Link Integrity Protocol........................................134
member link sequence numbers.........................136
NxT1 service.......................................................133
overview.............................................................133
packet distribution, round-robin.........................136
platform considerations......................................135
protocol layering.................................................135
unsupported features..........................................137
MLP. See MLPPP
MLPPP (Multilink PPP)................................................337
aggregating T1 or E1 lines...................................303
aggregation limits...............................................308
authentication.....................................................315
bundle................................................................303
bundle limits.......................................................308
bundle name and RADIUS..................................317
commands, contextual differences of.................314
configuring..........................................................312
ECMP..................................................................303
encapsulation......................................................317
endpoint discriminator.......................................304
features...............................................................308
fragmentation
configuring dynamic....................................328
configuring static.........................................326
overview......................................................324
interface stacking................................................304
interfaces, monitoring.........................................333
member link sequence numbers.........................308
MRRU.................................................................304
NxT1 service.......................................................303
Index
729
Index