Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 591

5.
6.
7.
atm pvc
auto-configure
Assign a profile to match the encapsulation type of bridged Ethernet.
host1(config-subif)#profile bridgedEthernet foo
(Optional) Assign subscriber identification.
host1(config-subif)#subscriber bridgedEthernet user charlie domain myisp
password lucy
(Optional) Verify your configuration.
host1#show atm subinterface atm 2/0.1
Use to configure a PVC on an ATM interface. Select one of the following
encapsulation types:
aal5autoconfig Enables autodetection of the 1483 encapsulation (LLC/SNAP
or VC multiplexed).
aal5snap Specifies a LLC encapsulated circuit; the LLC/SNAP header
precedes the protocol datagram.
aal5mux ip Specifies a VC multiplexed circuit. This option is used for IP
only.
Example
host1(config-subif)#atm pvc 6 0 11 aal5autoconfig
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure an ATM subinterface to support a dynamic interface. Specifies
the types of dynamic encapsulation that the ATM 1483 subinterface detects and
accepts.
For detailed information about how to use this command, see "auto-configure"
on page 531.
Example 1 Enables autodetection for the bridged Ethernet encapsulation type
using the default lockout time range, 1–300 seconds
host1(config-subif)#auto-configure bridgedEthernet
Example 2 Enables autodetection for the bridged Ethernet encapsulation type
using a nondefault lockout time range of 3600–21600 seconds (1–6 hours)
host1(config-subif)#auto-configure bridgedEthernet lockout-time 3600 21600
Example 3 Disables encapsulation type lockout for the bridged Ethernet
encapsulation type
host1(config-subif)#auto-configure bridgedEthernet lockout-time none
Chapter 17: Configuring Dynamic Interfaces
Configuring Bridged Ethernet Dynamic Interfaces
559