Changing Vlan Subranges - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
vlan profile
vlan service-profile

Changing VLAN Subranges

Changing VLAN subranges within a bulk-configured VLAN range includes the following
tasks:
The following sections describe how to perform these tasks.
680
Configuring VLAN Dynamic Subinterfaces
Use the no version to remove the association between a policy list and an
interface or a profile.
See vlan policy.
Use to add a nested profile assignment to a base profile for a dynamic VLAN
subinterface.
A nested profile assignment references another profile that configures attributes
for a dynamic upper-interface type over the VLAN subinterface.
Examples
host1(config-profile)#vlan profile pppoe vlanProfilePppoe
host1(config-profile)#vlan profile ip vlanProfileIP
Use the no version to remove the profile assignment for the upper-interface
encapsulation type.
See vlan profile.
Use to specify a service profile name for a dynamic VLAN and to enter Service
Profile Configuration mode. Service profiles contain user and password
information, and are used in route maps for subscriber management and to
authenticate subscribers with RADIUS.
You can specify a service profile name with up to 80 alphanumeric characters.
Example
host1(config)#vlan service-profile vlanClass1Service
host1(config-service-profile)#
Use the no version to delete the service profile.
See vlan service-profile.
Adding new VLAN subranges to an existing VLAN range
Removing VLAN subranges from an existing VLAN range
Modifying a VLAN subrange by shortening or expanding the subrange values
Merging multiple VLAN subranges belonging to an existing VLAN range
Changing the administrative state of VLAN subranges