JUNOSe 11.1.x Link Layer Configuration Guide
Figure 39: Example of Configuring IPv4 and IPv6 over PPPoE
To configure IPv4 and IPv6 interface columns over static PPPoE:
1.
2.
3.
4.
5.
6.
7.
8.
394
Configuring PPPoE for Ethernet Modules
IPv4
IPv4
PPP interface
PPP interface
PPPoE subinterface
PPPoE subinterface
PPPoE interface
VLAN
Gigabit Ethernet
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet interface.
host1(config)#interface gigabitEthernet 2/0/1
Specify VLAN as the encapsulation method.
host1(config-if)#encapsulation vlan
The VLAN major interface is added.
Create a VLAN subinterface by adding a subinterface number to the interface
identification command.
host1(config-if)#interface gigabitEthernet 2/0/1.1
Assign a VLAN ID for the subinterface.
host1(config-if)#vlan id 1
Create a PPPoE subinterface.
host1(config-if)#pppoe
Specify PPPoE as the encapsulation method on the interface.
host1(config-if)#pppoe subinterface gigabitEthernet 2/0/1.1.1
host1(config-if)#encapsulation ppp
Specify the order of preference for the primary authentication protocol.
host1(config-if)#ppp authentication pap chap eap
Enable IPv6 processing on an interface without assigning an explicit IPv6 address
to that interface.
IPv6