Bulk Dynamic Interface Configurations; Profiles - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

For e series broadband services routers - link layer configuration
Table of Contents

Advertisement

JUNOSe 11.1.x Link Layer Configuration Guide

Bulk Dynamic Interface Configurations

E Series routers support dynamic interfaces on two types of static interfaces: ATM
and VLAN. This chapter provides configuration information for ATM and then for
VLANs.
E Series routers support dynamic ATM 1483 subinterfaces over static ATM interfaces.
E Series routers support the following types of dynamic interfaces over VLAN major
interfaces:
Internet Protocol version 4 (IPv4) is supported for all bulk-configured dynamic
interface columns over dynamic ATM 1483 subinterfaces and over dynamic VLAN
subinterfaces.
Currently, Internet Protocol version 6 (IPv6) is supported only when PPP or MLPPP
is the layer immediately below the IPv6 layer in the interface column. IPv6 is not
supported directly over dynamic ATM 1483, dynamic bridged Ethernet, or dynamic
VLANs. Bulk-configured dynamic interface columns that support IPv6 include the
following:
For more information about IPv4, see chapter Configuring IP in JUNOSe IP, IPv6, and
IGP Configuration Guide. For more information about IPv6, see chapter Configuring
IPv6 in JUNOSe IP, IPv6, and IGP Configuration Guide.

Profiles

You can use profiles to configure dynamic interfaces over ATM and VLAN interfaces.
A profile is a set of characteristics that can be dynamically assigned to interfaces. By
using a profile, you reduce the management of a large number of interfaces by
applying a set of characteristics to multiple interfaces.
When you are configuring a large number of interfaces with the same attributes at
the higher layers, you can use a profile to factor out all the common attributes of
each layer into one place. This action affects one or more dynamic layers of the
624
Overview
Dynamic VLAN subinterface over static VLAN major interface
IP over dynamic VLAN subinterface
IP over PPPoE over dynamic VLAN subinterface
Dynamic IPv6 over dynamic PPP over dynamic ATM 1483
Dynamic IPv6 over dynamic MLPPP over dynamic ATM 1483
Dynamic IPv6 over dynamic PPP over dynamic PPPoE over dynamic ATM 1483
Dynamic IPv6 over dynamic MLPPP over dynamic PPPoE over dynamic
ATM 1483
Dynamic IPv6 over dynamic PPP over dynamic PPPoE over dynamic VLAN
Dynamic IPv6 over dynamic MLPPP over dynamic PPPoE over dynamic VLAN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1.x

Table of Contents