Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 611

ipv6 unnumbered
ipv6 virtual-router
l2tp policy
ppp aaa-profile
Use the no version to disable source address validation.
See ipv6 sa-validate.
Use to enable or disable IPv6 processing on an interface without assigning an
explicit IPv6 address to that interface.
Example
host1(config-profile)#ipv6 unnumbered loopback 0
Use the no version to remove the IPv6 address from the interface.
See ipv6 unnumbered.
Use to specify a VR in an IPv6 profile. Dynamic interfaces created with the profile
are assigned to this VR.
Example
host1(config-profile)#ipv6 virtual-router westford01
Use the no version to remove the VR assignment from the profile. If no VR is
specified via RADIUS, then any subsequent use of the profile to create a dynamic
interface fails for lack of a VR.
See ipv6 virtual-router.
Use to assign a policy list to the ingress or egress of an interface to which the
profile is attached.
Example
host1(config-profile)#l2tp policy secondary-input my-policy
Use the no version to remove the association between a policy list and a profile.
See l2tp policy.
Use to assign an AAA profile to static and dynamic, multilink and nonmultilink
PPP interfaces.
The PPP application associates the AAA profile with the interface and passes the
AAA profile to AAA for authentication.
If an AAA profile is deleted after it has been assigned to an interface, AAA denies
the authentication and logs a message.
When you remove an AAA profile, it does not remove any corresponding bindings
between PPP interfaces or interface profiles and the AAA profile. If an AAA profile
Chapter 17: Configuring Dynamic Interfaces
Configuring a Dynamic Interface from a Profile
579