Table of Contents
Advertisement
JUNOSe 11.1.x Link Layer Configuration Guide
show atm subinterface
600
Monitoring Upper-Layer Dynamic Interfaces and Profiles
OutBytes Number of bytes transmitted on this interface
InErrors Number of incoming errors received on this interface
OutErrors Number of outgoing errors on this interface
InPacketDiscards Number of incoming packets discarded on this interface
OutDiscards Number of outgoing packets discarded on this interface
Example
host1#show atm aal5 interface atm 3/0
AAL5 Interface ATM 3/0 operational status:
time since last status change: 00:08:46
SNMP trap link-status: disabled
Auto configure ATM 1483 status: disabled
InPackets:
0
InBytes:
0
OutPackets:
0
OutBytes:
0
InErrors:
0
OutErrors:
0
InPacketDiscards: 0
OutDiscards:
0
See show atm aal5 interface.
Use to display the current state of all ATM subinterfaces, all ATM subinterfaces
configured on a specified ATM physical interface, or a specific ATM subinterface.
To specify an ATM subinterface for ERX7xx models, ERX14xx models, and
ERX310 router, use the slot/port.subinterface format.
slot Number of the chassis slot
port Port number on the I/O module
subinterface Number of the subinterface in the range 1–2147483647
To specify an ATM subinterface for E120 and E320 routers, use the
slot/adapter/port.subinterface format.
slot Number of the chassis slot
adapter Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
port Port number on the IOA
subinterface Number of the subinterface in the range 1–2147483647
lowerLayerDown
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 and is the answer not in the manual?