Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 178

JUNOSe 11.1.x Link Layer Configuration Guide
146
Monitoring MLFR
Frame relay DCE interface mlframe-relay Name of the MLFR bundle
N391 Value of the N391 full-status polling counter
N392 Value of the N392 error threshold counter
T392 Value of the T392 polling verification timer
Configured LMI type: one of the following options:
ANSI ANSI T1.617 Annex D
Q933A ITU-T Q.933 Annex A
Cisco Original Group of Four specification developed by DEC, Northern
Telecom, Stratacom, and Cisco
None Suppresses LMI
status is up Availability of the MLFR bundle: up or down
Number of interface down transitions Number of times the interface has
become unavailable
Time since last status change Elapsed time since LMI information changed
Enquiries received Total number of LMI status inquiries received by
the DCE on this interface
Enquiry responses sent Total number of LMI status responses sent by
the DCE on this interface
Full enquiry responses sent Total number of LMI full status responses
sent by the DCE on this interface
Async updates sent Total number of LMI ASYNC updates sent by the
DCE on this interface
Unknown messages received Total number of unknown LMI messages
received on this interface
Loss of sequencing detected Total number of times a loss of sequencing
in received LMI messages was detected by the DCE on this interface
No response timeouts Total number of times a timeout occurred without
receiving a status inquiry from the DTE on this interface
Last sequence number sent Last sequence number sent on this interface
Last sequence number received last sequence number received on this
interface
Example 1
host1#show frame-relay lmi brief
LMI information for frame relay DTE interface mlframe-relayTEST
DTE parameter N391 is 6, N392 is 3, N393 is 4, T391 is 10
Configured LMI type is ANSI, status is up
Number of interface down transitions is 0
Time since last status change 00:05:39