Table of Contents
Advertisement
JUNOSe 11.1.x Link Layer Configuration Guide
NOTE: If VC ranges are configured for the dynamic ATM 1483 subinterface associated
with the base profile you want to delete, you must use the no atm bulk-config
command to remove the VC ranges before you can use the no profile command to
remove the associated base profile.
profile atm1483 bulk-config-name
Configuring Overriding Profile Assignments
Configuring overriding profile assignments includes the following tasks:
The following sections describe how to perform these tasks.
Assigning an Overriding Profile to an ATM PVC
You can assign an overriding profile to a single ATM PVC within a bulk-configured
VC subrange. Typically, the overriding profile includes debugging attributes to help
you identify and troubleshoot problems with the ATM 1483 dynamic subinterface
column created on the specified PVC.
To assign an overriding profile to an ATM PVC within a bulk-configured VC subrange:
1.
646
Configuring ATM 1483 Dynamic Subinterfaces
See profile.
Use to assign the base profile configured for a dynamic ATM 1483 subinterface
to the VC range configured on a static ATM AAL5 interface.
You must specify both of the following:
Name assigned to the VC range on an ATM AAL5 interface, as specified in
the atm bulk-config command
Name assigned to the base profile for a dynamic ATM 1483 subinterface
Example
host1(config-if)#profile atm1483 bulk-config-name myBulkConfig
atm1483BaseProfile
Use the no version to remove the profile assignment.
See profile atm1483 bulk-config-name
Assigning an overriding profile to an ATM PVC within a bulk-configured VC
subrange
Removing an overriding profile assignment from an ATM PVC
Removing overriding profile assignments from a VC range or VC subrange
Configure both of the following:
Base profile for the bulk-configured VC range on the static ATM AAL5
interface. The VC range consists of one or more VC subranges.
Advertisement
Table of Contents
Troubleshooting
