Monitoring Mlfr - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
interface mlframe-relay
member-interface

Monitoring MLFR

Use the commands in this section to display information about MLFR interfaces.
You can set a statistics baseline for an MLFR bundle or subinterface using the baseline
frame-relay interface mlframe-relay command. Similarly, you can set a statistics
baseline for an MLFR link with the baseline frame-relay multilink interface
command. Use the delta keyword with the show commands described below to
display statistics with the baseline values subtracted.
After you configure multilink Frame Relay, you can use the show frame-relay
commands to view information about the multilink. For information about these
commands, see "Configuring Frame Relay" on page 107.
You can use the output filtering feature of the show command to include or exclude
lines of output based on a text string you specify. Refer to the section show
Commands in JUNOSe System Basics Configuration Guide, for details.
baseline frame-relay interface
140
Monitoring MLFR
Use to create a Frame Relay major interface, also known as the MLFR bundle.
Example
host1(config-if)#interface mlframe-relay group2
Use the no version to delete the MLFR bundle.
See interface mlframe-relay.
Use to add an MLFR interface also known as an MLFR bundle member to an
MLFR bundle.
Example
host1(config-if)#member-interface serial 2/0:1
Use the no version to remove the specified interface from the MLFR bundle.
See member-interface.
Use to set a statistics baseline for the Frame Relay layer on MLFR bundles, Frame
Relay interfaces, subinterfaces, and circuits.
Specify the keyword mlframe-relay and the name of the MLFR bundle to set a
baseline for the Frame Relay statistics on an MLFR bundle.
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.