Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 635

Detected 1483 encapsulation If the encapsulation type is set to
aal5autoconfig, displays the 1483 encapsulation type detected on the
subinterface (displays AUTO until a packet is detected)
Detected dynamic interface Type of dynamic upper interface detected
during autoconfiguration: bridged Ethernet, IP, PPP, PPPoE, or (if no packet
has been received) none
Interface types in lockout Encapsulation types currently experiencing
lockout: bridged Ethernet, IP, PPP, PPPoE, or none
Lockout state (seconds) Settings of encapsulation type lockout for the
upper-layer encapsulation type indicated
Min Minimum lockout time, in seconds
Max Maximum lockout time, in seconds
Current Current lockout time, in seconds; displays 0 (zero) if lockout
is not occurring
Elapsed Time elapsed into the lockout time, in seconds; displays 0
(zero) if lockout is not occurring
Next Lockout time for the router to use for the next lockout event, in
seconds
Assigned profile For each dynamic interface type, indicates whether or not
a profile is assigned and, if assigned, displays the profile name
Subscriber info Subscriber login information for the specified dynamic
interface type (bridged Ethernet or IP)
SNMP trap link-status Trap link status: enabled or disabled
InPackets Number of packets received on this interface
InBytes Number of bytes received on this interface
OutPackets Number of packets transmitted on this interface
OutBytes Number of bytes transmitted on this interface
InErrors Number of errors received on this interface
OutErrors Number of outgoing errors on this interface
InPacketDiscards Number of incoming packets discarded on this interface
InPacketsUnknownProtocol Number of incoming packets with an unknown
protocol type
OutDiscards Number of outgoing packets discarded on this interface
Example 1 Displays the current state of all ATM subinterfaces
host1#show atm subinterface
Interface ATM-Prot VCD VPI VCI Type
Monitoring Upper-Layer Dynamic Interfaces and Profiles
Chapter 17: Configuring Dynamic Interfaces
Circuit
Encap MTU Status
Interface
Type
603