Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 731

Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
Use to display a summary of all configured ATM VCs and reserved VC ranges.
You can specify one or more of the following keywords individually or in
combination:
vpi Displays VCs on a specific VPI
category Displays VCs that have a specific service category
status Displays VCs with a certain status
To display only a summary of all reserved VC ranges on the router, specify the
reserved keyword with no other keywords. This includes VPI/VCI ranges reserved
for use by dynamic ATM 1483 subinterfaces.
Field descriptions
Interface Interface identifier
VPI Virtual path identifier
VCI Virtual channel identifier
VCD Virtual circuit descriptor
Type Type of circuit: PVC
Encap Encapsulation method: AUTO, AAL5, MUX, SNAP, ILMI, F4-OAM
Category Service type configured on the VC: UBR, UBR-PCR, NRT-VBR,
RT-VBR, or CBR
Rx/Tx Peak Peak rate, in Kbps
Rx/Tx Avg Average rate, in Kbps
Rx/Tx Burst Maximum number of cells that can be burst at the peak cell
rate
Status State of the virtual circuit: Up or Down
Start VPI Starting virtual path identifier (inclusive) of the reserved VC range
Start VCI Starting virtual circuit identifier (inclusive) of the reserved VC
range
End VPI Ending virtual path identifier (inclusive) of the reserved VC range
End VCI Ending virtual circuit identifier (inclusive) of the reserved VC range
Example 1 Displays all VCs and reserved VC ranges on the router
host1#show atm vc
Interface VPI VCI
------------ --- ---- ---- ---- ----- ---- ----- ----- ----- ---
ATM 3/0.2 0 101
ATM 3/0.3 0 102
...
ATM 3/0.8099 1 8099 8099 PVC
Cate Rx/Tx Rx/Tx Rx/Tx Sta
VCD Type Encap gory Peak
4375 PVC AUTO CBR 1000
4376 PVC AUTO CBR 1000
SNAP UBR
Monitoring Dynamic Interfaces and Profiles
Avg Burst tus
0 0 UP
0 0 DOWN
0 0 0 UP
699