Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 496

JUNOSe 11.1.x Link Layer Configuration Guide
show vlan subinterface
464
Monitoring Bridged Ethernet
Address IP address of the entry
Hardware Addr Physical (MAC) address of the entry
Example
host1:vr1#show ip mac-validate interface atm 8/0.1
ATM8/0.1: Strict
Address
180.1.0.2
See show ip mac-validate interface.
Use to display configuration and status information for a specified VLAN
subinterface or for all VLAN subinterfaces configured on the router.
Use the summary keyword to display only the counts of all VLAN subinterfaces
and VLAN major interfaces configured on the router.
Field descriptions
Interface Type and specifier of the VLAN subinterface. For more information
about specifying the ATM physical interface on which you want to configure
the VLAN subinterface, see Interface Types and Specifiers in JUNOSe Command
Reference Guide.
Status Status of the VLAN subinterface: up, down, lowerLayerDown,
notPresent
MTU Maximum allowable size (in bytes) of the maximum transmission
unit for the VLAN subinterface
Svlan Id S-VLAN ID value, if configured
Vlan Id VLAN ID value for the VLAN subinterface
Ethertype S-VLAN Ethertype value, if configured
Total VLAN interfaces Total numbers of VLAN subinterfaces and VLAN
major interfaces configured on the router; this is the only field that appears
when you specify the summary keyword
Example 1 Displays full status and configuration information for all VLAN
subinterfaces configured on the router
host1#show vlan subinterface
Interface
------------------------- ---------- ---- -------- -------- ---------
ATM 3/0.1.2
ATM 3/0.1.3
ATM 3/1.1.1
ATM 3/1.1.2
ATM 3/2.1.1
FastEthernet 4/5.1
6 vlan subinterfaces found
Hardware Addr
0000.1111.2222
Status MTU Svlan Id Vlan Id
Up 1522 ----
Up 1522 ----
Up 1522 ----
Up 1522 ----
Down 1526 4
Up 1522 ----
Ethertype
11 ----
12 ----
13 ----
14 ----
255 0x9200
1 ----