Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 81

For e series broadband services routers - link layer configuration
Table of Contents

Advertisement

ubr
vbr-nrt
vbr-rt
Example
host1(config-subif-atm-vc)#cbr 15000
host1(config-subif-atm-vc)#exit
Use the no version to restore the default service category, UBR without a PCR.
See cbr.
Use to configure the UBR service category on an ATM data PVC.
You can optionally specify a PCR, in Kbps, in the range 0–149760 (for OC3 ATM
modules) or 0–599040 (for OC12 ATM modules).
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example
host1(config-subif-atm-vc)#ubr 5000
host1(config-subif-atm-vc)#exit
Use the no version to restore the default service category, UBR without a PCR.
See ubr.
Use to configure the variable bit rate, nonreal time (VBR-NRT) service category
on an ATM data PVC.
You must specify all of the following parameters:
PCR, in Kbps, in the range 0–149760 (for OC3 ATM modules) or 0–599040
(for OC12 ATM modules)
SCR, in Kbps, in the range 0–149760 (for OC3 ATM modules) or 0–599040
(for OC12 ATM modules)
Maximum burst size (MBS), in cells, in the range 0–16777215
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example
host1(config-subif-atm-vc)#vbr-nrt 50000 10000 150
host1(config-subif-atm-vc)#exit
Use the no version to restore the default service category, UBR without a PCR.
See vbr-nrt.
Chapter 1: Configuring ATM
Configuring Individual ATM PVC Parameters
49

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1.x

Table of Contents