JUNOSe 11.1.x Link Layer Configuration Guide
interface atm
profile
subscriber
560
Configuring Bridged Ethernet Dynamic Interfaces
Example 4 Either command reenables encapsulation type lockout for the
bridged Ethernet encapsulation type using the default lockout time range
host1(config-subif)#auto-configure bridgedEthernet
host1(config-subif)#no auto-configure bridgedEthernet lockout-time
Example 5 Permanently locks out the bridged Ethernet encapsulation type until
the auto-configure bridgedEthernet command is issued
host1(config-subif)#no auto-configure bridgedEthernet
Use the no version to terminate detection of the specified encapsulation type
or, if the lockout-time keyword is specified, to restore the lockout time range
to its default value, 1–300 seconds.
See auto-configure.
Use to select an ATM interface or ATM 1483 subinterface.
For information about specifying the ATM interface or subinterface, see "interface
atm" on page 532.
Examples
host1(config)#interface atm 5/0.1
host1(config)#interface atm 4/0/2
Use the no version to remove the interface or subinterface.
See interface atm.
Use to assign a profile.
You must specify the encapsulation type to which the profile applies:
bridgedEthernet, ip, ppp, pppoe , or any.
Specify a profile name with up to 80 alphanumeric characters.
Example
host1(config-subif)#profile bridgedEthernet foo
Use the no version to remove a profile assignment.
See profile.
Use to configure a local subscriber on the E Series router to support authentication
and configuration from RADIUS for a dynamic bridged Ethernet or IPoA interface.
For detailed information about how to use this command, see "subscriber" on
page 556.
Example