Example 2: Bridging With Vlans - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

6.

Example 2: Bridging with VLANs

The following example illustrates how to configure transparent bridging with VLANs
over a Fast Ethernet interface.
NOTE: You can also configure transparent bridging with VLANs over a bridged
Ethernet interface. For information, see "Configuring VLANs over Bridged Ethernet"
on page 453 in "Configuring Bridged Ethernet" on page 443.
1.
2.
3.
4.
Configure a subscriber (client) bridge group interface over the bridged Ethernet
interface as a peer to the PPPoE interface. Assign the interface to the bridge
group you created in Step 1.
host1(config-subif)#bridge-group westford01
Create the bridge group.
host1(config)#bridge westford02
Create a Fast Ethernet interface.
host1(config)#interface fastEthernet 2/0
Create a VLAN major interface by specifying VLAN as the encapsulation method
for the interface.
host1(config-if)#encapsulation vlan
Create a VLAN subinterface by adding a subinterface number to the interface
fastEthernet command.
host1(config-if)#interface fastEthernet 2/0.1
Chapter 15: Configuring Transparent Bridging
Configuration Examples
489