Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 313

For e series broadband services routers - link layer configuration
Table of Contents

Advertisement

ppp mru
ppp passive-mode
default value (30) if you omit the optional value for maximum renegotiation
attempts.
When both IPv4 interface columns and IPv6 interface columns are configured
over a PPP link-layer interface, the router terminates the PPP session only when
the PPP client exceeds the configured maximum number of renegotiation
attempts for both the IPv4 interface and the IPv6 interface.
Example 1 Sets the maximum number of LCP renegotiation attempts to 5
host1(config-if)#ppp max-negotiations lcp 5
Example 2 Sets the maximum number of IPCP renegotiation attempts to 30
(the default)
host1(config-if)#ppp max-negotiations ipcp
Example 3 Sets the maximum number of LCP, IPCP, and IPv6CP renegotiation
attempts to 15
host1(config-if)#ppp max-negotiations 15
Example 4 Restores the maximum number of LCP, IPCP, and IPv6CP
renegotiation attempts to the default value, 30
host1(config-if)#no ppp max-negotiations
Use the no version to restore the default value, 30 renegotiation attempts.
See ppp max-negotiations.
Use to control the negotiation of the maximum receive unit (MRU).
Specify the number of bytes, in the range 64–65535.
We recommend you coordinate this value with the network administrator on
the other end of the line.
If the value configured for the PPP MRU is greater than the value of the lower-layer
MRU minus the PPP header length, the router logs a warning message and uses
the lesser of the configured MRU value or the lower-layer MRU value minus the
PPP header length to negotiate the local MRU.
If the value configured for the PPP MRU conflicts with a similar value configured
for another protocol, such as the MTU value for PPPoE, the router uses the lesser
of the two values.
Example
host1(config-if)#ppp mru 576
Use the no version to restore the default value, which causes PPP to use the
lower-layer MRU minus the PPP header length as the MRU value.
See ppp mru.
Chapter 8: Configuring Point-to-Point Protocol
Optional Configuration Tasks
281

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1.x

Table of Contents