Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 735

show profile
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
Use to display information about profiles.
To display information about a specific profile, use the name keyword.
To display a list of profiles configured on the router, use the brief keyword.
Field descriptions
Profile Name of the profile that is displayed
IP address IP address and subnet mask of the interface, or none if the
interface is unnumbered
Unnumbered interface Specifier for the unnumbered interface, or none if
the interface is numbered
Router Name of the virtual router (VR) assigned to the profile; interfaces
created by the profile are attached to this VR
Directed Broadcast Enabled or disabled
ICMP Redirects Enabled or disabled
Access Route Addition Enabled or disabled
Network Address Translation Enabled or disabled; domain location (inside
or outside)
Source-Address Validation Enabled or disabled
Ignore DF Bit Enabled or disabled
Filter Option Packets Router filters out packets with IP options; enabled or
disabled
Administrative MTU MTU size configured on the profile
TCP MSS value Maximum segment size for TCP SYN packets traveling
through the interface
Inactivity Timer Inactivity timer setting; enabled or disabled
Route Map Name Route map applied to the IP interface subscriber; enabled
or disabled
Auto Detect Router automatically detects packets that do not match any
entries in the demultiplexer table; enabled or disabled
Auto Configure Dynamic creation of subscriber interfaces on a primary IP
interface; enabled or disabled
IGMP Enabled or disabled
static-groups Displays address of any static groups configured for IGMP
Input policy Name of input policy and whether statistics are enabled or
disabled
Monitoring Dynamic Interfaces and Profiles
703