Removing Overriding Profile Assignments From A Vlan Range Or Vlan Subrange - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
2.
3.
4.
5.
Removing Overriding Profile Assignments from a VLAN Range or VLAN
Subrange
When you issue the no vlan bulk-config command to remove an entire VLAN range
(and all VLAN subranges within that VLAN range), the router also removes any
overriding profile assignments configured for VLAN IDs within those VLAN subranges.
For example, the following command removes the bulk-configured VLAN range
named myBulkConfig and any overriding profile assignments for VLAN IDs within
the VLAN subranges belonging to myBulkConfig.
When you issue the no vlan bulk-config command to remove a particular VLAN
subrange in a bulk-configured VLAN range, the router also removes any overriding
profile assignments for VLAN IDs within that VLAN subrange. However, overriding
profile assignments for VLAN IDs within other VLAN subranges in the VLAN range
remain intact. For example, the following command removes one VLAN subrange
(S-VLAN IDs 50–150 and VLAN IDs 150–250) and only those overriding profile
assignments associated with this subrange.
auto-configure vlan
672
Configuring VLAN Dynamic Subinterfaces
host1(config-if)#no profile vlan override bulk-config-name myBulkConfig vlan 202
overrideVoiceSubscriber
Select the dynamic VLAN subinterface on which the VLAN dynamic subinterface
column resides.
host1(config)#interface gigabitEthernet 4/0.101
Use the shutdown command to disable the dynamic VLAN subinterface. The
shutdown command deletes the VLAN dynamic subinterface column and removes
the dynamic VLAN subinterface.
host1(config-if)#shutdown
Send traffic over the VLAN subinterface. This action re-creates the VLAN dynamic
subinterface column with the original base profile association.
The router now uses the information in the base profile instead of the information
in the overriding profile to create subsequent VLAN dynamic subinterface columns
for the specified VLAN ID or S-VLAN ID.
(Optional) Use the show vlan profile override command to verify the removal
of the overriding profile assignment.
For more information about using this command, see "Monitoring Dynamic
Interfaces and Profiles" on page 689.
host1(config-if)#no vlan bulk-config myBulkConfig
host1(config-if)#no vlan bulk-config myBulkConfig svlan-range 50 150 150 250
Use to configure the static VLAN major interface to support autodetection of an
VLAN dynamic interface type.
You must issue this command to enable creation of a dynamic VLAN subinterface.