Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 465

show radius override
show radius remote-circuit-id-delimiter
PPP Packet Log
PPP State Log
PPP Chap Challenge Length
PPP Passive Mode
PPP Multilink
PPP IPCP Netmask Option
PPP AAA Profile
PPP Multilink Fragmentation : disabled
PPP Multilink Fragment Size : (use MTU)
PPP Multilink Reassembly
PPP Multilink Mrru
PPP Initiate IP
PPP Initiate IPv6
PPPoE Max Sessions
PPPoE Always-offer
PPPoE Remote-Circuit-Id
PPPoE Log PPPoeControlPacket: Disabled
PPPoE duplicate-protect
PPPoE ACNAME
PPPoE URL
PPPoE MOTM
PPPoE Service-Name table
See show profile.
Use to display the current override settings configured on the RADIUS client
(LNS) for the NAS-IP-Address [4], NAS-Port-Id [87], Calling-Station-Id [31], and
NAS-Identifier [32] RADIUS attributes.
Field descriptions
nas-ip-addr Override setting for the NAS-IP-Address attribute
nas-port-id Override setting for the NAS-Port-Id attribute; value is
remote-circuit-id if configured with radius override nas-port-id
remote-circuit-id command
calling-station-id Override setting for the Calling-Station-Id attribute; value
is remote-circuit-id if configured with radius override calling-station-id
remote-circuit-id command
nas-info Virtual router that generates the NAS-IP-Address and NAS-Identifier
attributes for AAA broadcast accounting packets; current virtual router or
authentication virtual router
Example
host1#show radius override
nas-ip-addr: nas-ip-addr
nas-port-id: remote-circuit-id
calling-station-id: remote-circuit-id
nas-info: from current virtual router
See show radius override.
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
: disabled
: disabled
: 16 - 32
: disabled
: disabled
: disabled
:
: disabled
: (use MRU)
: disabled
: disabled
: 2
: Disabled
: Enabled
: Enabled
: CYM9876
: http://www.urlofinterest.com
: goodmorning
: myServiceTable1
Monitoring PPPoE
433