Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 707

shutdown
svlan ethertype
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
Example 1 Assigns an overriding profile (test1OverridingProfile) to the dynamic
VLAN subinterface with VLAN ID 202
host1(config-if)#profile vlan override bulk-config vlan 202 test1OverridingProfile
Example 2 Assigns an overriding profile (test1DebugProfile) to the S-VLAN
subinterface with S-VLAN ID 100 within the VLAN subinterface with V-LAN ID
202
host1(config-if)#profile vlan override bulk-config svlan 100 202
test1OverridingProfile
Example 3 Removes the overriding profile assignment from the VLAN
subinterface with VLAN ID 202, and restores the original base profile assignment
host1(config-if)#no profile vlan override bulk-config vlan 202
test1OverridingProfile
Use the no version to remove the overriding profile assignment for the VLAN ID
or S-VLAN ID and restore the original base profile assignment.
See profile vlan override bulk-config.
Use to disable an interface.
When you disable a dynamic VLAN subinterface, the shutdown command deletes
the VLAN dynamic subinterface column and removes the dynamic VLAN
subinterface.
Example
host1(config-subif)#shutdown
Because the shutdown command removes the dynamic VLAN subinterface from
the router, issuing a subsequent no version of this command has no effect; that
is, it does not restart the disabled subinterface.
See shutdown.
Use to specify the available Ethertypes that a packet must use to create a dynamic
VLAN subinterface.
Choose one of the following Ethertype values:
8100 Specifies Ethertype value 0x8100, as defined in IEEE Standard 802.1q
88a8 Specifies Ethertype value 0x88a8, as defined in draft IEEE Standard
802.1ad
9100 Specifies Ethertype value 0x9100
autoconfig Specifies that the packet can use any Ethertype to create a
dynamic VLAN subinterface
Examples
Configuring VLAN Dynamic Subinterfaces
675