Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual page 392

JUNOSe 11.1.x Link Layer Configuration Guide
Table 17: show ppp interface mlppp Output Fields (continued)
360
Monitoring Multiclass MLPPP
Field Name
PPP multilink multiclass
reassembly
mlppp interfaces found
Time since last baseline
receive class, transmit class
Interface statistics
Receive Class number
fragments in reassembly list
reordered
discarded fragments/bytes
last received sequence number
Transmit Class number
fragments
last sent sequence number
Bundle name
MLPPP interface interfaceName
Field Description
Configuration of reassembly of the multiclass MLPPP
interface: enabled or disabled. If reassembly is
enabled then it also lists the QoS traffic classes on
which reassembly is enabled.
Number of MLPPP interfaces configured
When baselining is configured, the time since the last
baseline was set is displayed in hours:minutes:seconds
or days/hours format
Number of multilink classes configured on the MLPPP
bundle
Statistics for data received by (in) and transmitted
(out) on the MLPPP interface:
packets Number of packets received and
transmitted on the interface
octets Number of octets received and
transmitted on the interface
errors Number of errors received and
transmitted on the interface
discards Number of packets discarded on
receipt or discarded before they were
transmitted
fragments Number of fragments received and
transmitted on the interface
Information about the packets of the specified
multilink class received by the router
Number of buffered fragments reassembled
Number of fragments reordered
Number of fragments and bytes that have been
discarded.
Sequence number of the last multiclass MLPPP packet
received
Information about the packets of the specified
multilink class transmitted by the router
Number of fragments that are sent by the router
Sequence number of the last multiclass MLPPP packet
sent
Name of the MLPPP bundle
Name and state (up or down) of the configured
MLPPP interface